Common Parameters of Sheet Metal Commands > Options

Use manipulators. When the flag is enabled the control manipulators in the 3D scene are shown.

Show labels. When the flag is enabled the special labels informing about the current parameter values are shown, which can also be used to change the value of the operation parameters.

Dynamic preview. The flag enables/disables the dynamic preview of the command.

Bend face completely. When the flag is set, the body will be completely bent along the selected line. This parameter is important when performing operations on the sheet metal of certain geometry (for example, when it is required to bend the sheet body with a cut along the specified line).

Check self-intersections. It allows you to monitor self-intersection of bent sheet faces. When the flag is set, system will not create bend that intersects with the source body.

Extend Wall Only. The parameter allows you to limit the length of the "flange" at the bend point.

See Also:

•Full List of Common Parameters