3D Node by Measurement Results

A 3D node based on the measurement results can be created in the Measure command for the following properties of the measured elements:

•StartX, StartY, StartZ, EndX, EndY, EndZ
A 3D node is created on the path (at the beginning or end, respectively);

•LocationX, LocationY, LocationZ
A 3D node is created on the surface at the starting point of the surface;

•Xmass, Ymass, Zmass
A 3D node is created in the center of mass;

•Distance
A 3D node is created on the first point of the segment that represents the minimum distance between the selected elements (the first point of the segment belongs to the first selected element).

If one of the properties listed above is selected in the list of measurement results, the node creation option is available in the automenu:

<N>

Create 3D Node

The node is created instantly at the moment of activating the option.