Circle Through Node

 Предыдущая страницаВ началоСледующая страница

The circles passing through a selected 2D node creation mode of the Circle20x20 Circle command can be called in one of the following ways:

Icon

Ribbon

CircleNotCentre

Draw > Construct > Circle > Circle through node

Keyboard

Textual Menu

<С>><T>

 

Automenu of the Circle20x20 <C> Circle command

<T>

Select a node for the circle to pass through

If this mode is already active, pressing <T> will switch the command to the circles centered at a selected 2D node creation mode.

 

Following methods of creating a circle are available in this mode:

•Through Three Nodes

•Through Two Nodes, Using Radius

•Through Two Nodes, with One Tangent

•Through Node, with One Tangent, Using Radius

•Through Node, with Two Tangents

In all these methods the construction starts with selecting a 2D node, for the new circle to pass through.

Upon activating this mode, you have access to the full set of automenu options of the Circle20x20 Circle command, which allows you to switch to any other mode.