Next Action upon Moving and Copying 2D Elements |
  
|
Next Action upon Moving and Copying 2D Elements |
|
Automenu of 2D elements' moving, copying and array creation commands (except Array by Table) contains options, that define next action of the system upon defining a last target point of the current transformation.
|
<Alt>+<X> |
Exit Command automatically when finished |
If this option is active, then, upon defining a last target point of the current transformation, the system will go into command standby mode.
|
<Alt>+<O> |
Repeat Command for selected elements |
If this option is active, then, upon defining a last target point of the current transformation, the system will proceed to defining new target points for applying the same command to the same objects again.
|
<Alt>+<N> |
Repeat Command for created elements |
If this option is active, then, upon defining a last target point of the current transformation, the system will proceed to defining new target points for applying the same command to the resulting elements.
This option is only available, when copying.
|
<Alt>+<A> |
Repeat Command for selected and created elements |
If this option is active, then, upon defining a last target point of the current transformation, the system will proceed to defining new target points for applying the same command both to resulting and initial elements at once.
This option is only available, when copying.
|
<Alt>+<S> |
Select new elements when finished |
If this option is active, then, upon defining a last target point of the current transformation, the system will go into the source elements selection mode for applying the same command to new set of elements.
See also:
