Edit Hatch Contour

In order to edit a hatch contour, select a hatch in the editing command and activate the following automenu option:

When this option is active, pressing within drawing window selects the nearest contour of the current hatch and launches editing of such contour. If the contour was defined via automatic search, or if the current hatch is created automatically in the 2D Projection command, or if it is a copy of an another hatch, the automenu will only contain the following options:

If the current contour is defined manually, then, upon its selection, the system launches editing of its nearest segment. The selected segment is indicated by thicker highlighting. In such case, the automenu may additionally contain following options:

Then you can perform one of the following actions:

•change position of one of the points of the selected segment;

•add a new point, thus splitting the current segment;

•change direction of the contour and numbering of its points;

•change shape of the selected segment.

Segments defined via graphic lines cannot be edited.

Topics in this section:

•Editing Point of Hatch Contour;

•Adding New Point to Hatch Contour;

•Changing Direction and Numbering of Points in Hatch Contour;

•Changing Trajectory of Section in Hatch Contour.